JSON-LD markup generated by Google Structured Data Markup Helper.

2005 Ford Econoline

  • 2005 Ford Econoline

    Ford Econoline
    Mileage
    185,678
    Service Date
    5/13/2022
    Services Performed
    • Has new plugs, coils and fuel filter. This helped a little, but still is not running right. Pulled van into the shop for inspection and did noticed that there was a fuel cap message on the dash. Inspected fuel cap and found that it is the wrong cap and will not thread in and seal tight. Install the correct cap and now this message is gone. Did confirm engine miss when pulling into the shop for inspection. Scanned computer for codes and found P0171 bank 1 too lean, P0174 bank 2 too lean, P0301 cylinder 1 misfire detected and P0457 Evap system leak detected. Fuel cap fixed the P0457 Evap code. Removed cylinder #1 coil and swapped it with cylinder #5 and now engine is setting a code for cylinder #5 misfire. This proves cylinder #1 coil is bad. Needs new coil and boot.
    • Inspection completed. See attached worksheet
    • #3 IGNITION COIL – Remove & Replace – V8 One
    • -Removed the rear wheel and brake calipers. Removed the rotors and replaced with new and applied a non directional finish to help the new pads break in correctly. Cleaned the caliper mounting slides and reassembled with new rear calipers & brake pads with anti-squeal to the backing. Flushed and bled the rear brake hydraulics as needed. Repacked rear wheel bearings and replaced seals as needed. Adjusted the rear park brakes to specs. Torqued the wheels to specs then road tested. Burnished in the rear pads on the road test. The brakes work good.
    • #5 ALTERNATOR DRIVE BELT – Remove & Replace – Gas – [Includes: Serpentine and V-Belt type Belt(s).]
    • -Removed the front wheels and brake calipers to the side. Removed the rotors and replaced with new and applied a non directional finish to help the new pads break in correctly. Cleaned the caliper slides and reassembled with new front brake pads with anti-squeal to the backing. Repacked the front wheel bearings and replaced new seals as needed. Torqued the calipers and wheels to specs then road tested. Burnished in the front pads on the road test. The brakes work good.
     
    Tony P. gave our service a 5 star review on 5/13/2022

Address

Dynamic Diesel & Bear Alignment
9911 Airport Way
Snohomish, WA98296-8229
(360) 862-9009

We Service